Feature Product
- IP69 waterproof - The camera is IP69 Rating waterproof. It can be placed outside and can be cleaned using a pressure washer. Withstanding the negative weather with working temperature -4F to 176F. In addition, the monitor's buttons are also waterproof.
- Amazing night vision - Built-in 28 infrared LEDs and CMOS sensor, infrared night vision fill light, HD night vision is safer. The camera's infrared light has a minimum illumination of 0.5 lux , whose night vision distance is 15 m. 140°wide angle provide you a wider visual experience, which make your driving more confident and safety.
- No Interference - Digital signals are more stable and clear than analog signal imaging. No any interference with other wireless devices, it can work as normal even car speed reaches 70MILE. The wireless transmission distance up to 150 ft in open empty area BUT the working vehicle is below 42 ft.
- Easy to install - Monitor is directly powered from the cigarette lighter socket Or ACC, the wire of camera is connected to the negative pole, and the red wire is connected to all 12-36V power supplies such as the tail lights or the running light. After then press the camera and the code switch of the monitor until the image is appeared. The extra tape is attached to the bottom of the monitor stand and you can paste it on the center console.
- Warranty -JoyTutus provides a one-year warranty and lifetime friendly customer service for the License Plate Wireless Backup Camera. This package includes: paste the bracket of the monitor*1 (with stickers), fixed bracket of the monitor*1 (with stickers), 7in monitor*1, car cigarette*1, angle adjustment screws *4, Antenna*1, camera*1, hex wrench*1, mounting bracket screws*4 (with 4 rubber ring), fixed camera screws*4, power cord*2 (57in and 118in).
Description
Joy tutus digital wireless wireless rearview camera set uses 28 infrared night vision lights for the better night images, helping drivers gain predictive power during night or low light driving. This wireless backup camera Kit can work as a full time camera on the rear of the travel or surrounding , this just based on your install method , camera need to get continuous power supply. Installation Guide Before installing, make sure you connect the power cable and antenna to the camera. Camera Connection: Step 1: Choose the camera locations. Step 2:Drill a 12mm Diameter Cable Hole and Secure the Camera With Two Screws.(Accessory Includes Screws) Step 3: Locate the reversing lights or running lights wiring on your vehicle. You may need to remove the interior panel in order to locate. Connect the red wire of the power cable to the positive and the black wire to the ground. Monitor Connection: Monitor is directly powered from the cigarette lighter socket or ACC, There is no need to run any wires from the camera to the monitor. ......................................................................................................................................... Tips We recommend doing a benchmark test before installation to insure that all components are working properly. Consult an experienced technician if you are not familiar with installing the Backup Camera.
0 komentar:
Posting Komentar